+91 98845 40315 | 99410 99014 info@powerswitchgears.com

Agility AE-04-024D-1-B-C Four Channel Relay Module

Agility AE-04-024D-1-B-C is a four-channel Agility relay board designed to connect compatible 24 VDC control outputs with independently switched machine circuits. Each channel incorporates an Omron G5Q Series electromechanical relay providing one changeover (SPDT) contact. The contact rating is specified as 10 A at 250 VAC or 30 VDC, depending on the connected load and switching duty. Freewheeling diodes help suppress coil turn-off transients, while DIN rail or panel mounting supports control-cabinet installation. This Four Channel Relay Module can organize four separate output commands without individual relay assemblies. Agility industrial relay interfaces provide additional switching configurations for automation applications in industrial installations.

BrandAgility
ProductRelay Board
Model NumberAE-04-024D-1-B-C

Agility AE-04-024D-1-B-C Relay Board – Technical Overview

SpecificationValue
Relay TypeElectromechanical Relay
Relay Contact TypeOne Change Over (SPDT)
Relay MakeOmron G5Q Series
Coil Voltage24 VDC
Number of Channels4 Channel Relay Board
Contact Rating10 A at 250 VAC / 30 VDC
Input InterfacePLC / Control signal compatible
Mounting TypeDIN Rail / Panel Mount
Relay Coil ProtectionFreewheeling Diode
IsolationElectrical isolation between control and load circuits
ApplicationPLC interface, automation control panels, machine control systems

The Agility AE-04-024D-1-B-C relay board provides four separately controlled relay outputs for automation panels where machine commands need individual switching contacts. Its Omron G5Q Series relays each provide one changeover (SPDT) contact, allowing the installer to use the normally open(NO) or normally closed(NC) path according to the circuit's required inactive state. A packaging machine, for example, might assign different channels to an auxiliary alarm, a machine-ready signal, or appropriately rated contactor-control circuits. Although these commands share one board, their switched contact paths remain individually wired.

The relay coils require 24 VDC, whereas the connected field circuits may use different voltages within the relevant contact limits. Each contact is specified at 10 A for 250 VAC or 30 VDC under the applicable switching conditions. The controller output must supply adequate coil current, and inductive or high-inrush loads require additional contact-duty assessment. When the control electronics operate at 5 VDC instead, the AE-04-005D-1-B-C provides four SPDT channels using 5 VDC Omron G5Q relays.

Freewheeling diodes limit the voltage transient produced during coil de-energization, and the module is listed for DIN rail or panel mounting. In a four-output control cabinet, clearly identifying each channel and separating coil wiring from switched load conductors makes troubleshooting easier. Applications requiring twice the number of 24 VDC-operated channels can use the AE-08-024D-1-B-C, which provides eight Omron G5Q SPDT relay positions. The number of independent commands, coil supply and actual contact load should guide model selection.