+91 98845 40315 | 99410 99014 info@powerswitchgears.com

Agility AE-04-005D-1-B-C 4 Channel Relay Card

Agility AE-04-005D-1-B-C is a four-channel Agility relay board designed to switch independent field circuits using a compatible 5 VDC control supply. The board incorporates Omron G5Q Series electromechanical relays, each providing one changeover (SPDT) contact for normally open(NO) or normally closed(NC) switching. Its specified contact rating is 10 A at 250 VAC or 30 VDC, subject to the connected load conditions. Freewheeling diode protection helps suppress voltage transients during coil de-energization. Suitable for DIN rail or panel mounting, the 4 Channel Relay Card supports electronic controller interfaces, machine automation and discrete output switching. Agility industrial relay components include alternative configurations for different control requirements.

BrandAgility
ProductRelay Board
Model NumberAE-04-005D-1-B-C

Agility AE-04-005D-1-B-C Relay Board – Technical Overview

SpecificationValue
Relay TypeElectromechanical Relay
Relay Contact TypeOne Change Over (SPDT)
Relay MakeOmron G5Q Series
Coil Voltage5 VDC
Number of Channels4 Channel Relay Board
Contact Rating10 A at 250 VAC / 30 VDC
Input InterfacePLC / Control signal compatible
Mounting TypeDIN Rail / Panel Mount
Relay Coil ProtectionFreewheeling Diode
IsolationElectrical isolation between control and load circuits
ApplicationPLC interface, automation control panels, machine control systems

The Agility AE-04-005D-1-B-C relay board provides four independently operated switching channels for automation equipment using 5 VDC relay coils. Each channel incorporates an Omron G5Q Series relay with a single changeover (SPDT) contact. This configuration allows individual control signals to operate separate external circuits without requiring four individual relay assemblies. For example, the outputs may be assigned to machine-status indications, auxiliary control functions or appropriately rated contactor interfaces. The common, normally open(NO) and normally closed(NC) contact terminals provide flexibility when defining the required switching state.

The 5 VDC coil specification is particularly relevant when connecting the board to electronic controllers or low-voltage automation interfaces. The controller output must provide sufficient coil drive current, as a logic-level signal alone may not operate an electromechanical relay. The stated 10 A contact rating at 250 VAC or 30 VDC should be evaluated against the actual load characteristics. For applications requiring only two independently controlled outputs, the AE-02-005D-1-B-C offers a 5 VDC two-channel alternative using Omron G2R Series relays.

Freewheeling diode protection helps limit inductive voltage spikes when the relay coils are switched off. The 4 Channel Relay Card supports DIN rail or panel mounting, allowing installation inside machine control cabinets and electrical enclosures. When four channels are required with a 24 VDC coil supply, the AE-04-024D-1-B-C provides an alternative using Omron G5Q relays. During installation, coil supply compatibility, terminal identification, contact load category and simultaneous channel operation should be considered. The four relay contacts remain individually switched despite being housed on the same board.