Agility AE-01-005D-1-B Single Channel 5V Relay Module
Agility AE-01-005D-1-B is a single-channel Agility relay board for switching an external circuit from a compatible 5 VDC control output. The board uses an Omron G2RL Series electromechanical relay with one changeover (SPDT) contact, providing normally open(NO) and normally closed(NC) switching options. Its contact rating is specified as 10 A at 250 VAC or 30 VDC under applicable load conditions. A freewheeling diode limits coil turn-off transients, while DIN rail or panel mounting supports control-cabinet installation. This Single Channel 5V Relay Module suits individual alarm, interlocking and auxiliary switching functions. Agility relay interface products cover additional control-circuit requirements.

| Brand | Agility |
| Product | Relay Board |
| Model Number | AE-01-005D-1-B |
Agility AE-01-005D-1-B Relay Board â Technical Overview
| Specification | Value |
|---|---|
| Relay Type | Electromechanical Relay |
| Relay Contact Type | One Change Over (SPDT) |
| Relay Make | OMRON G2RL Series (Other make available on request) |
| Coil Voltage | 5 VDC |
| Number of Channels | 1 Channel |
| Contact Rating | 10 A at 250 VAC / 30 VDC |
| Input Interface | PLC / Control signal compatible |
| Mounting Type | DIN Rail / Panel Mount |
| Relay Coil Protection | Freewheeling Diode |
| Isolation | Electrical isolation between control circuit and load circuit |
| Application | PLC interface, automation control panels, machine control systems |
The Agility AE-01-005D-1-B relay board provides one electromechanical switching channel for equipment requiring a single relay-operated output. Its Omron G2RL Series relay has a changeover (SPDT) contact with common, normally open(NO) and normally closed(NC) connections. For example, a control panel can assign the relay to an alarm indication, an equipment-enable signal or a suitably rated contactor interface. Only one command operates the contact, making the arrangement appropriate when additional relay channels are unnecessary.
The coil operates at 5 VDC, while the switched circuit may use a different voltage within the contact's specified limits. The stated rating is 10 A at 250 VAC or 30 VDC, subject to the actual load type and switching duty. A suitable controller output or driver must supply the coil current; a 5 V logic signal alone does not guarantee direct-drive compatibility. Freewheeling diode protection helps limit the inductive voltage spike when the coil is de-energized. Where the same 5 VDC command must operate two linked changeover contacts, the AE-01-005D-2-B offers a single-channel DPDT arrangement using an Omron G2R relay.
DIN rail and panel mounting are listed for installation in an automation enclosure. During wiring, the contact's normal state, coil polarity and connected load characteristics should be identified on the circuit diagram. An alternative for a 12 VDC control supply is the AE-01-012D-2-B, which also has one relay channel but provides DPDT contacts. These differences matter when replacing an existing relay or planning a new control interface.